Change the Sharp XR-10S projector lamp

Written by
  • Shelagh M.
  • 8 years ago

Sharp XR-10SThis guide shows you for the quickly replace the Sharp XR-10S projector lamp.

When to replace

Sharp_PG-MB66X_projector_Sharp_DT-510_projector_lamp_hoursYour Sharp XR-10S projector lamp operates for 3,000 hours in Eco Mode and 2,000 hours when on the Bright setting. When there are only 150 hours left, the projector lamp indicator will start flashing red. Other end of life signs include a deteriorating picture and color quality. When it’s time to replace the lamp, you’ll need model  Sharp DT-510.
You can see the hours remaining for Lamp Life Status. The remaining hours will be shown on the chart Lamp Usage chart.

Six reasons to invest in authentic

The Internet has been flooded with counterfeit projector lamps claiming to be “compatible” with the Sharp XR-10S projector. For the few dollar you save, these projector lamps bring more problems to the table.

Invest in authentic. Don’t be fooled. How to recognize an authentic projector lamp.

Find this lamp sold on Amazon by these authorized dealers:

Installing the projector lamp

Sharp_XR-10S_projector_Sharp_DT-510_replace_projector_lamp_cover
Before replacing the Sharp DT-510 projector lamp follow these important safety tips:

  • Press STANDBY/ON on the projector or STANDBY on the remote control to put the projector into standby mode.
  • Wait until the cooling fan stops.
  • Disconnect the power cord.
  • Unplug the power cord from the AC socket.
  • Allow the projector to cool down for at least one hour. If should be cool to the touch.

Place the Sharp XR-10S projector onto a soft service and turn over to access the lamp cover. Remove the user service screw holding the projector lamp cover in place. Slide the cover off away from the projector and place it to one side.
Sharp_XR-10S_projector_Sharp_DT-510_replace_projector_lampRemove the screws holding the Sharp DT-510 projector lamp in place. Grab the wire handle and gently pull out the lamp.
Hold the Sharp DT-510 projector lamp by the handle and pull it in the direction of the arrow. DO NOT tilt it.
Take the new Sharp DT-510 projector lamp and align the tab on the lamp unit cover and place it while pressing the tab to close it. Be careful not to touch the actual bulb as the oil from your fingers left on the lamp will burn black holes onto the lamp that appear on screen.
Note: The used Sharp DT-510 projector lamp contains mercury and should be properly recycled. Don’t throw it into regular garbage.
Fasten the securing screws. Slide the lamp cage cover back on in the direction of the projector. Then tighten the user service screw.
Reset the lamp timer

To reset the Sharp XR-10S projector lamp timer:

Sharp_XR-10S_projector_Sharp_DT-510_projector_lamp_timer

  • While simultaneously holding down MENU/HELP, ENTER and the down arrow on the projector.
  • Press STANDBY/ON on the projector.
    LAMP 0000H” is displayed, indicating that the lamp timer is reset

Extend the life of the Sharp DT-510 projector lamp:

  • Chose the ECO MODE mode to to dim the projector lamp and lower power consumption. This will extend the lamp life by up to 130%.
  • Keep your air filters clean to avoid overheating the projector.
  • Every 24 hours, turn off the projector and let it stand for 1 hour
  • Make sure there is enough airflow around the Sharp XR-10S projector particularly if it’s been permanently mounted.
  • Learn more with Top tips for extending DLP projector lamp life.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Shares